THE
MINI-MRIX SYSTEM
SYSTEM
(AUTOMATED pH ADJUST WITH METAL RECOVERY)
This system is designed for heavy metal removal
and water polishing to maintain compliance at low capital and
operational costs. Designed to allow limited budgets to treat
for Copper, Lead, Nickel, Cobalt, Zinc, Chrome and Uranium, Arsenic
and Selenium. Oxidization/reduction systems for the removal of
arsenic and selenium. The system features automatic controls with
data logging, incoming pH adjust and outgoing pH adjust to ensure
compliance. Rated at 2-5 gpm, with metal loadings of up to 10
ppm, the system is a very cost effective solution for those small
problems with a big impact.
These system provide effluent streams with metal levels that
are usually non-detectable.
Designed for off site regeneration or dump and fill waste streams
where it is not cost effect to put in a fully regeneration systems.
A perfect system for pre paint lines, washing operations and
low flow, low metal content ground water remediation. These system
can be monitored remotely if required.
For higher flows and metal loadings, see our MRIX systems with
flows from 10 gpm to 300 gpm. Metal recovery feeds at up to 6-10
g/l with concentrations between 60 and 80 g/l for value recovery.
Mini-MRIX system features -
- Automated controls
- Skid mount air compressor for valve control
- Pressure and flow sensors (analog)
- Data logging of flow(1), pressure(2), pH (2), metering pump
operation
- pH adjust of input water
- Prefilter
- Carbon filter
- Post carbon filter
- Dual Ion Exchange columns with 2.5 cu.ft of resin each
- Air operated butterfly valves
- Failure mode defaults to recycle loop
Options include -
- Chelated resins for divalent and trivalent metals
- oxidizer canisters for arsenic and cyanide
- reduction for selenium
- arsenic and selenium adsorption media
- carbon media
|
